Caring For Your Car Cover

Car Cover Instructions:

When placing your car cover on, your vehicle, make sure there are no obstructions or sharp edges in the way. Knowing what is in the way before putting on your car cover can prevent unwanted tears, scratches, or getting caught.

A. Take the elastic end with the flap and hook it underneath the front bumper for a proper grip.

B. Then, slowly drape the rest of the car cover over the vehicle until it reaches the other side of the vehicle.

C. Lastly, take the other elastic end and hook it underneath the rear bumper. Make sure you go around the whole car and tighten the car cover until it feels secure. Any loose ends can cause car covers to get blown off, so for those who live in windy areas, we recommend purchasing a Cable and Lock Kit Set for safety and convenience. If you own a Cable and Lock Kit Set, you can find the grommet instructions below. Top of Page

When removing your car cover, start at the rear bumper and just unhook the car cover. Then, go to the front of the car, and unhook the car cover from the front bumper. 

Then, depending on your vehicle:

1. Fold both ends inwards, so that they meet at the middle. Once the car cover reaches the center of the car, pull it towards you, while folding the car cover inwards.

2. In case you own a vehicle where the top is too high, slowly fold the car cover to the other side. Once the car cover reaches the other side, fold the car cover in half.

It is preferred that one fold car covers while on top of the car because it prevents dust accumulation from touching walls or from the ground, and the car cover will not accidentally rip or tear when folded elsewhere. Top of Page

How do I clean my car cover?

We recommend that you wash your car cover using mild detergent mixed with water. Do not use a dryer. Air dry all car covers for maximum durability. Top of Page

In case of Extreme Cold: Frozen Car Cover

In case your car cover gets frozen to the car, which may happen on occasion, apply warm water until the car cover can be lifted off with ease. Do not chisel or pull at car covers while frozen in order avoid ripping or tearing. Allow the car cover to air dry until placing it back on the car. Top of Page

What do I do about my antenna?

In case your antenna doesn't retract or detach, each order includes an antenna patch for the car cover.

1. Place the car cover onto the vehicle as normal.

2. Stop when you reach the antenna.

3. Mark the spot on your car cover where the antenna would go and place on the patch. Then, simply cut a small circle inside the patch, slip the antenna through, and continue unfolding your car cover.

In case you do not receive an antenna patch, contact a sales representative for further assistance at 1-800-221-0718. Top of Page

Instructions for using a Cable and Lock Kit Set

All our grommets are pre-installed on the car cover, so you don't have to waste time setting them up.

A. Find one of the grommets along the car cover and slip the cable through one.

B. Reach underneath the car and slip through to the other side. Then, slip the the cable through the opposite grommet.

C. Pull both ends with loops together and close the lock. This should lock the car cover in place.

If you need help or have questions, for further assistance contact a sales representative at 1-800-221-0718. Top of Page